When the board is free of those two pins you can just lift it out. You'll probably need assistance from someone who knows how to unsolder things so as not to damage the board. Then remove the board from the donor part the same way, drop in your old board and solder the pins. Your old key will then work and no reprogramming needed. The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to validate the digit and resume, repeat the process until you have entered the full code. This should allow your Dodge Caliber to start without having to remove the immobiliser. How do I disable my security immobilizer? You can also deactivate Toyota immobilizer using the door key, where you turn the key on your door as if opening it but do not open the door. Hold the key in place for around 30 seconds to let the immobilizer unit know that you have the right key. I have the immobilizer lights on. Car start and shut off in 2 sec. Tried left the key in on position with charger to battery for couple of hours, also touching both positive and negative wire but none of them work. Get locksmith come and re-program the key or even trying to by pass the immobilizer. Factory alarm is Passive. Passive Anti-Theft System. It is a transponder chip in the key and a transceiver ring around the lock cylinder. If the alarm starts go off when set and not unlocked with remote or key, inserting the programmed key into the ignition and starting will disarm the system, shut off the horn and flashing lights and allow the vehicle to start. KVFrVm.

how do i disable immobilizer